Home     All DIY Kits     All Expansion Boards     Accessories     Web Store     OEM/ODM     Contact  
     
    First Glance X5000 Kits      
     
 
❶ Front panel
 
❷ Rear panel
   
 
     
    Hardware Installation
     
 
❶ Required toolkit
  Screw diver 1 pc
  Tweezer 1 pc
 
❷ Required Accessories for X800K HDD board
  Screw M3 x 6mm 6 pcs
  Screw nut M3 x 3mm 4 pcs
  Spacer M2.5 x 6mm 4 pcs
  USB bridge 1 pc
  Power connection wire 1 pc

     
❸ Required Accessories for X4000 DAC board
  Screw M2.5 x 6mm 8 pcs
  Spacer M2.5 x 20mm 4 pcs
  HDMI bridge 1 pc
 
❹ Required Accessories for metal case
  Screw M3 x 4mm 4 pcs
  Power switch 1 pc
  Volume knob 1 pc

     
❺ Push a screws (M2.5*6mm) up through the mounting hole on the underside of the X800 and screw the spacer (M2.5*12mm) down until it is hand tight.
 
❻ Push a screws (M3*6mm) up through the mounting hole on the topside of the X800 and screw the nut (3mm) down but not over the nut.
 
     
❼ Insert your hard disk into the SATA socket.  then use your thumb and forefinger of your left hand to press the X800 and HDD as below arrow pointed vigorously and screw down.
 
❽ Place your Raspberry Pi on top of X800 and screw the spacer (M2.5*20mm) down until it is hand tight.











 
     
❾ Plugs the X5000 board straight into your Raspberry Pi B+'s GPIO header, insert the HDMI bridge, Connect the power cable from X800 to X4000 and screw down (M2.5*6mm)
 
❿ Insert the USB bridge to connect Raspberry Pi and X800, Connect the power switch，volume potentiometer and power adapter to X5000 and test all functions before putting it into the case
   
     
⓫ Remove the Micro-SD card and USB bridge from Raspberry Pi，pick up the board in a tilted position and put it into the case.
 
⓬ Install the power switch. Please note the gap position.
 
     
⓭ Screw down the X800 board (Screw M3 x 6mm, 3 positions), connect the power switch and volume potentiometer to X5000, Unscrew the screws on RCA connectors.
 
⓮

Place the washer down onto the handle of volume potentiometer and screw the nut down.
 
     
⓯ Insert the volume knob.
 
⓰ Connect the speaker connector to X5000.
 
     
⓱ Insert the rear cover and screw down (M3 x 4mm screws), screw down the RCA connector and finally insert the USB bridge.
 
   
 
   
     
 
       
 
     
  © 2017 SUPTRONICS LIMITED, ALL RIGHTS RESEVERED