Home     All DIY Kits     All Expansion Boards     Accessories     Web Store     OEM/ODM     Contact  
     
    Hardware Installation X6000-7.1CH
     
 
❶ Required tool (Optional accessories)
  Screw diver 1 pc
 
❷ Required Accessories
  Screw M2.5 x 6mm 8 pcs
  Spacer M2.5 x 20mm 4 pcs
  HDMI bridge 1 pc
     
❸ Push a screws (M2.5*6mm) up through the mounting hole on the underside of the Raspberry Pi.
 
❹  Screw the spacer (M2.5*20mm) down until it is hand tight
     
     
❺ Plugs the X6000 board straight into your Raspberry Pi B+'s GPIO header and insert the HDMI bridge.
 
   


   
     
 
 
       
 
     
  © 2017 SUPTRONICS LIMITED, ALL RIGHTS RESEVERED