Home     All DIY Kits     All Expansion Boards     Accessories     Web Store     OEM/ODM     Contact  
     
    First Glance X6000-8.0CH
Kits
     
 
Front panel
 
Rear panel
   
 
     
    Hardware Installation
     
 
Required toolkit
  Screw diver 1 pc
  Tweezer 1 pc
 
Required Accessories for X800K HDD board
  Screw M3 x 6mm 6 pcs
  Screw nut M3 x 3mm 4 pcs
  Spacer M2.5 x 6mm 4 pcs
  USB bridge 1 pc
  Power connection wire 1 pc

     
Required Accessories for X4000 DAC board
  Screw M2.5 x 6mm 8 pcs
  Spacer M2.5 x 20mm 4 pcs
  HDMI bridge 1 pc
 
Required Accessories for metal case
  Screw M3 x 4mm 4 pcs
  Power switch 1 pc

     
Push a screws (M2.5*6mm) up through the mounting hole on the underside of the X800 and screw the spacer (M2.5*12mm) down until it is hand tight.
 
Push a screws (M3*6mm) up through the mounting hole on the topside of the X800 and screw the nut (3mm) down but not over the nut.
 
     
Insert your hard disk into the SATA socket.  then use your thumb and forefinger of your left hand to press the X800 and HDD as below arrow pointed vigorously and screw down.
 
Place your Raspberry Pi on top of X800 and screw the spacer (M2.5*20mm) down until it is hand tight.











 
     
Plugs the X6000 expansion board straight into your Raspberry Pi B+'s GPIO header, insert the HDMI bridge, Connect the power cable from X800 to X4000 and screw down (M2.5*6mm)
 
Insert the USB bridge to connect Raspberry Pi and X800, Connect the power switch and power adapter to X800 and test all functions before putting it into the case
 








 
     
Remove the Micro-SD card from Raspberry Pipick up the board in a tilted position and put it into the case.
 
Install the power switch. Please note the gap position.
 
 
     
Screw down the X800 board (Screw M3 x 6mm, 3 positions as yellow arrow pointed), nipped the connector of power switch  using the tweezer and insert it into the power socket on x800 as orange arrow pointed.
 
Insert the rear cover and screw down (M3 x 4mm) and finally insert the USB bridge.
     
 
     
     
 
       
 
     
  © 2017 SUPTRONICS LIMITED, ALL RIGHTS RESEVERED