Home     All DIY Kits     All Expansion Boards     Accessories     Web Store     OEM/ODM     Contact  
     
    First Glance X800          
     
 
❶ Top view
 
❷ Bottom view
   
 
     
    Hardware Installation
     
 
❶ Required tool
  Screw diver 1 pc
 

     
❷ Required Accessories for X800K HDD board
   

     
❺ Push a screws (M2.5*6mm) up through the mounting hole on the underside of the X800 and screw the spacer (M2.5*12mm) down until it is hand tight.
 
❻ Push a screws (M3*7mm) up through the mounting hole on the topside of the X800 and screw the nut (3mm) down but not over the nut.
 
     
❼ Insert your hard disk into the SATA socket.  then use your thumb and forefinger of left hand to press the X800 and HDD as arrow pointed hardly and screw down.
 
❽ Insert the HDMI adapter board to Raspberry Pi, Place your Raspberry Pi on top of X800 and screw down (M2.5*6mm screws).











 
     
❾ Push a screws (M3*7mm) up through the mounting hole on the topside of the X800 and screw the spacer (M3*15mm) down until it is hand tight.
 
❿ Insert the USB bridge.
 
     
⓫ Connect the power cable from X800 to Raspberry Pi pin header - Pin 4 (5V, Read wire) and Pin 6 (Ground, Black wire).
 
   
   
     
 
 
       
 
     
  © 2017 SUPTRONICS LIMITED, ALL RIGHTS RESEVERED